Industrial Jackshaft
Description:
| Jackshaft operators are used on any door with a shaft, sprockets and chain as a driving element. They can be installed on high lift, vertical lift, but also on specially adapted standard lift sectional doors or rolling doors and grilles. They are normally mounted on either side of the door. |
| |
| MEDIUM DUTY |
- Instant Reverse Limited Duty 1/2 HP Motor
- 5L V-Belt, Chain and Sprocket Reduction
- #41 Chain on Final Drive
- Output Shaft Speed: 39 rpm
- Adjustable Friction Clutch
- Mechanical Brake
- Thermal Protection
- C2 Wiring, B2 or D1 can be very easily set
- Pre-wired for Open Override, Safety Reverse, Radio Control
- Wall, Hood or Shelf Mounted on either side of the door
- Clearance: side room required is 15"
- Maximum Recommended Door Height: 14"
Options: Spreader, Hoist on Left, Delay on Reverse |
| |
|
| |
| HEAVY DUTY COMMERCIAL |
- Floor level disconnect for Manual push up Operation
- Continuous Duty Motors up to 1 HP
- 5L V-Belt, Chain and Sprocket Reduction
- #50 Chain on Final Drive
- Output Shaft Speed: 41 rpm
- Adjustable Friction Clutch
- Mechanical Brake
- Heavy Duty Reversing Contactor
- Full Overload Protection
- C2 Wiring, B2 or D1 can be very easily set
- Pre-wired for Open Override, Safety Reverse, Radio Control
- Wall, Hood or Shelf Mounted on either side of the door
- Clearance: side room required is 15"
Main Options: Spreader, Delay on reverse, Timer to close, Double limit, Electronic Control Board
Model HJ: model with automatic chain hoist as well as floor level disconnect for emergency egress. |
| |
|
| |
| HEAVY DUTY INDUSTRIAL |
- Chain hoist with electrical cut out
- Continuous duty TEFC motors up to 2 HP
- Worm gear in oil bath
- Solenoid Brake
- Heavy Duty Reversing Contactor
- Full Overload Protection
- C2 Wiring, B2 or D1 can be very easily set
- Pre-wired for Open Override, Safety Reverse, Radio Control
- Output shaft speed: 38 rpm
- Wall, hood or shelf mounted on either side of the door
- Clearance: side room required is 15"
Main Options: Nema 4/12, Nema 7/9, Adjustable friction clutch, Spreader, Hoist on left, Delay on Reverse, Timer to Close, Double Limit, Electronic Control Board |
 |
|
